Introduction of the Machine > Starting "Setup Guide"
*
Starting "Setup Guide"

This section describes how to start the "Setup Guide" from the Additional Functions menu.

The "Setup Guide" is designed to assist you in making the machine's required settings.

Load Paper

Set Date and Time

Make Fax Settings

Connect Telephone Cables

Adjust Color with "Auto Gradation Correction"

Set Up Network Connection

Finish "Setup Guide"

  1. Press (Main Menu).

  1. Press the right Any key to select <Additional Func.>.

  1. Use [], [] or (Scroll Wheel) to select <System Management Set.>, then press [OK].

If the System Manager ID and System Password have been set, enter the System Manager ID and System Password using - (numeric keys), then press (Log In/Out).

  1. Use [], [] or (Scroll Wheel) to select <Setup Guide Start>, then press [OK].

  1. Use [], [] or (Scroll Wheel) to select <Yes>, then press [OK].

The "Setup Guide" is displayed on the display.

Remark
  • Once the "Setup Guide" starts, it cannot be stopped.
  • Press [Back] to return to the previous screen.

  • Information About the Keys
  • Press the Left/Right Any key to select the alternative key at the bottom of the display.
  • Press [] [] [] [] to move the cursor position.
  • Use (Scroll Wheel) to move the cursor position.
  • Press [OK] to set the entry or to proceed to the next screen.
  • Press [Back] to return to the previous screen.


  1. Make sure the screen on the left is shown on the display, then press [OK] to proceed to the "Setup Guide."

  1. Make sure the screen on the left is shown on the display, then press [OK] to proceed to the "Setup Guide."

The screen explains how to operate the "Setup Guide" using the keys on the operation panel. For details on the key operation, see "Information About the Keys," shown above.

  1. Make sure the screen on the left is shown on the display, then press [OK] to proceed to the "Setup Guide."

Check that all the packing materials are removed from the main unit and the cartridges. If not, refer to the instruction sheet "Unpacking the Machine" and remove them all.

  1. Make sure the screen on the left is shown on the display, then press [OK] to proceed to the "Setup Guide."

The auto obtain IP address function enables the machine to get the IP address after connecting the LAN cable to the machine.

  • Make sure that the network is connected to the machine.

  1. Make sure the screen on the left is shown on the display, then press [OK] to proceed to the "Setup Guide."

Do not connect the USB cable at this point even if you use the machine as a local printer by directly connecting the machine to the computer.

  • During the software installation, you will connect the USB cable. (When using the network function, the USB cable is not required.)

  1. Make sure the screen on the left is shown on the display.

Go to "Load Paper."

  • If the toner cartridges have not been set in the machine or the tabs and tape have not been removed from the toner cartridges, the <Set Toner Cartridge Again> screen appears. You will need to finish the cartridge installation before you proceed. (See, "Replacing the Toner Cartridge with a New One.")

  • Back To Top